Question:

Boat Tilt/Trim remote switches

by Guest10521100 | 2 years, 9 month(s) ago

the bow and stern tilt switches do not work. If I touch a ground wire to either side of the switch's the motor goes up only. The switch on the shift leaver works fine. I have a 1985 18' Winner with a 175 horse

Tags:

Report

Answer The Question I've Same Question Too

Follow Question

SIMILAR QUESTIONS

How can I get NMEA 2000 tilt trim on my Garmin GPSMAP
I have a Garmin GPSMAP that shows all the engine gauges except the tilt and trim. The Garmin shows the gauge, but w...
Category: Recreation/Outdoors | Answers: 1
Mercury tilt/ trim problem
The 60 HP motor on our boat will not trim up. Checked the switch and fluid, all seem good. Any ideas to get this...
Category: Boat Repair | Answers: 4
91 Mercury 60 tilt and Trim
My 91 Mercury 60 tilt and trim only work in one direction at a time. If I reverse the two wires from the switch it...
Answers: 1
My tilt & Trim will not work
1989 mercury 90 hp, just had the tilt and trim motor replaced 3 months ago and worked fine. The boat sat for around...
Answers: 2

CAN YOU ANSWER?

Tilt/Trim: will trim up but not down
Posted: 2 years, 8 month(s) ago
what is the difference between tilt and no tilt for ignition switch
Category: Autos | Posted: 2 years, 9 month(s) ago
Merc. 1989 115 tilt/trim
Engine is in raised position with tilt lock engaged, tilt/trim will not operate up or down, the relays do have powe...
Posted: 2 years, 10 month(s) ago
tilt trim removel
i am trying to remove the top bolt of a 48 hp tilt trim but cant make it budge it has some thereads on one end ins...
Category: Boat Repair | Posted: 3 years ago
how to remove the trim and tilt in a 75hp mercury mariner
Posted: 1 year, 11 month(s) ago