2000 dodge dakota 4.7 camshaft location step by step details on replacing camshaft sensor on a

1 ANSWERS

1. Arslan Masaud
   

   hello The Crankshaft Position (CKP) sensor is located at the right-rear side of the engine cylinder block CKP Sensor Location/Removal/Installation - 4.7L V - 8 Engine It is positioned and bolted into a machined hole in the engine block Disconnect CKP electrical connector at sensor. Remove CKP mounting bolt CKP Sensor Location/Removal/Installation - 4.7L V - 8 Engine Carefully pry sensor from cylinder block in a rocking action with two small screwdrivers. Remove sensor from vehicle. Check condition of sensor o-ring. INSTALLATION Clean out machined hole in engine block. Apply a small amount of engine oil to sensor o-ring. Install sensor into engine block with a slight rocking action. Do not twist sensor into position as damage to o-ring may result CAUTION: Before tightening sensor mounting bolt, be sure sensor is completely flush to cylinder block. If sensor is not flush, damage to sensor mounting tang may result. Install mounting bolt and tighten to 28 N·m (21 ft. lbs.) torque. Connect electrical connector to sensor. hope it helps

   Report (0) (0)  |   2 years, 8 month(s) ago